Dymo labelwriter 450 not printing text5/21/2023 ![]() ![]() That is, if 11354 was 32x57mm, it should be rotated 90 degrees on the roll. I belive they should be 57x32mm, since the 30252/11010 labels are created as 28x89 mm, and not 89x28 mm. So printing works indeed correct on labels with that kind of format(ie smaller width than height), but I'm still not clear on the issue with labels with wider width than height. They are apparently the metric version of 30252, so the results should be identical(apart from the fact that I didn't load the labels correctly, causing some offset to the print): Hi, I had some dymo 99010 labels that I used for testing. I will be happy to provide it, if at all possible. Please let me know if you need any more information from me. I am able to print correctly to the printer using the official Dymo software(tested on a macbook). The printer itself is shared on the network using an OpenWRT-based router. My computer setup is Linux LMDE(LMDE 2 Betsy, 3.16.0-7-amd64 #1 SMP Debian 3.16.59-1 () x86_64 GNU/Linux) and the drivers for the printer are the Dymo CUPS Drivers for Linux(v. This leads me to belive that it is something in the commands from gLabels to the printer, that causes an issue. I can verify that the printer prints correctly by printing from a custom size paper(with the dimensions of the label in landscape mode) in Libre Office Writer, as seen in the following screenshot. switching around height and width), the prints are always rotated to a vertical position. In the beginning, I thought the issue was incorrect custom label creation(Label 11354 isn't included in 3.01 and 4.3.1, so I had to create it myself), but regardless of how I did it(e.g. I have experimented with printer settings(auto rotate, keep orientation, 180 degrees, 270 degrees), but that doesn't change anything. ![]() But the actual "frame" of the label seem to always be vertical, as indicated by the outline box. Its clear that the text is being rotated correctly, although it is also reversed. The thick box is a box that I have drawn on the label, while the thin box is created with the "print outlines" setting in the print menu. The label rotation is always 90 degrees off. ![]() The labels are produced with the continuous app image, but the same behavior is present in all versions mentioned above. Please see attached photo of labels(Dymo 11354) produced with both horizontal and vertical orientation. GLabels Continuous appimage(downloaded from github). I have experienced this in the following versions:
0 Comments
Leave a Reply. |